This QR Plate kit has been developed to provide a Quick Release solution for adding or removing the DOF Reality Honeycomb Table option to and from your rig so that other controllers can be fitted in it's place on a QRUHD Base Mount.
The kit is designed to fit to the underside on either side of the DOF Reality Honeycomb table so that you can have your controllers, specifically (but not limited to) the Honeycomb Aplha and Bravo, in the configuration you choose.
You could go one step further and fit 2 kits to the Honeycomb table enabling you to swap sides easily for operation of the Bravo on left or right at any time you choose.
Watch the video for more information.
IMPORTANT:
- Always use the 2x Thumbscrews/M6 Form ‘G’ washers that are supplied with the QRUHD Base Mount to secure the QR Plate to the QRUHD Base Mount once locked in place.
- Always only use the QR Levers when the Thumbscrews are removed to lock/unlock the QR Plate.
- Never use the QR Levers to eject heavy devices, just unlock them a little and then use both hands to remove the controller/QR Assembly
This kit includes the following parts:
- 1x QRUHDDOFR-HCT QR Plate
- 1x QRUHDDOFR-HCT Adapter Plate
- 6x 19mm 'Bobbins'
- 6x M6x40mm CSK s/s Skt Screws
- 8x M6 s/s Nuts
- 2x M6x12mm CAP s/s Skt Screws
- 4x M4x20mm CSK s/s Skt Screws
You will need a QRUHD Base Mount fitted to your rig to use this kit.
Instructional Video
The principles of this kit are almost identical to the QRMax version, so please use the video below to fit to your DOFR Honeycomb Table Addon.
QRMaxDOFR-HCT for QR of the Honeycomb Table
More information on DOF Reality motion rigs can be found on their website: DOF Reality
Note: This item 3D printed, there will be obvious print lines on this product due to the nature of 3D printing.
