Joystick Extension for Virpil (VPC) 200 x 100 Rake 12°

This custom Joystick extension fits the Virpil (VPC) Joystick ranges and is ideal when using a centre mount.

The main tube is 30mm in diameter has an offset of 100mm and adds a height of 200mm, ideal when centre mounting.

Unlike most others available, this extension is fully hardwired allowing easy no-fuss swap out between joystick handles and extension/no extension modes¹.

VPC grips can be mounted in any orientation and later notched grips in 22.5° rotational steps from straight.

The extension has the same anti-twist notches that match the newer VPC Bases and Grips and the component that mates with the base is made from a extremely hard wearing Polycarbonate Blend composite to keep it in shape.

Compatability

• Virpil bases support Virpil and Thrustmaster grips. 
• No other bases or grips are considered compatible at this time.

Bases

• VPC WarBRD Series Base²
• VPC MongoosT-50 Series Base²

Grips

• Thrustmaster Warthog Grip
• Thrustmaster F/A-18C Grip
• Thrustmaster Cougar Grip
• VPC WarBRD Grip
• VPC V.F.X Grip
• VPC MongoosT-50 Series Grips
• VPC Constellation ALPHA Series Grips
• VPC Constelation DELTA

Notes:
1. Thrustmaster and Virpil (VPC) themselves recommended for the USB to be disconnected when swapping between joysticks/extensions attached to their Joystick bases, we ask you to adhere to this advice too!

2. Virpil (VPC) only:

• Remove the 2 bolts holding the female grip connector in place in the VPC Base before attaching the extension to prevent damage to the connectors. Refer to the VPC Base user manual for more information. (see photo #5)
• The plug pulls out of the Virpil grips to make connecting easier. (see photo #8)

Note: This item is 3D printed. There will be obvious print lines on this product due to the nature of 3D printing. The colour of the base interface, plug and socket holder (not visible once installed) will vary depending on model chosen. We have colour coded them to make sure we send you the right one!